Motorola fx7400 Integrator Manual page 33

Mounting Using the Mounting Plate
Position the mounting plate on a flat surface (wall or shelf). Position the release tab on the top. See
1.
Mark the hole locations using the mounting plate as a guide. See
2.
drill holes (appropriate for the surface material) at the marked locations.
NOTE For wood surfaces, drill two 1/8" diameter by 7/8" deep holes. For drywall/masonry surfaces, drill two
3/16" diameter by 7/8" deep (min) holes and install using the provided anchors.
Mounting Holes
Mounting Plate, Front
Figure 3-1
Use a hand screw driver to install the mounting plate (do not use a power driver). Do not use
CAUTION
excessive torque, and tighten the screws so that they are just snug on the screw head stops (see
Figure 3-1). If the reader does not engage the mounting plate, loosen the screw(s) 1/8 to 1/4 turn and
try again.
Reposition the mounting plate over the mounting holes and secure using the supplied fasteners (as
3.
appropriate for the surface material).
NOTE Mount the reader with the cable connections up or down, depending on the installation requirements.
Position the reader by aligning the markers on the metal base plate and the wall bracket, positioning the
4.
key-slot holes over the mounting screws. Gently slide the reader down (see
To remove the reader, press the release tab and slide the reader up while gently pulling out.
5.
Installation and Communication
Figure
Release Tab
3-1. Remove the mounting plate and
Screw Head Stops
(4 typical)
Figure 3-1) to lock into place.
3 - 3
Figure 3-1.