Configure Reader; Reader Parameters - Motorola fx7400 Integrator Manual

4 - 14 FX Series RFID Readers Integrator Guide

Configure Reader

Use the
Configure Reader

Reader Parameters

Configure reader settings using this window.
Configure Reader
Figure 4-16
•
- Sets the reader name. Accepts up to 32 alphanumeric characters.
Name
•
- Describes the reader. Accepts up to 32 alphanumeric characters.
Description
•
- Provides information on the reader location. Accepts up to 32 alphanumeric characters.
Location
•
- Name of the reader manager contact. Accepts up to 32 alphanumeric characters.
Contact
•
Operation Status
•
Serial Connection Timeout
there is no timeout for the serial console. The minimum acceptable value for this field is 15 seconds.
•
Antenna Check
not attempt to check if an antenna is connected on the ports. When
presence of an antenna on the port and only transmits RF if an antenna is connected.
•
Set Properties
These settings only affect the display. Use
submenu to access the following functions.
- Displays the reader current operation status (
- Timeout value (in seconds) for the serial console of the reader.
- Controls the antenna sensing feature on the reader.
- Sends the changes to the reader.
Commit/Revert on page 4-31
, , or
Enabled Disabled Unknown
indicates that the reader does
Disabled
, the reader monitors the
Enabled
to save the changes.
).
indicates that
0