Timer Operation - Daikin FTK25JV1NB Manual

Si-86.book Page 44 Friday, June 23, 2000 10:26 AM
Instruction

Timer Operation

Timer functions are useful for automatically switching the
air conditioner on or off at night or in the morning. You can
also use OFF TIMER and ON TIMER in combination.
OFF TIMER operation
l
Chec k that the clock is correct.
If not, set the clock to the present time. (See page 40.)
1
Press while the air conditioner
OFF
is operating.
AM
2
Press until the time setting
TIMER
reaches the point you like.
l
Every pressing of either button increases or decreases
the time setting by 10 minutes. Holding down either
button changes the setting rapidly.
3
OFF
Press once again.
AM
n
To cancel the timer:
Press .
CANCEL
Notes on OFF TIMER
l
NIGHT SET MODE
When the OFF TIMER is set, the air conditioner automatically
adjusts the temperature setting (0.5ºC up in COOL, 2.0˚C down
in HEAT) to prevent excessive cooling (heating) for your
pleasant sleep.
44
is displayed.
AM
blinks.
* Previous time setting
appears on display.
ON
OFF
Then the TIMER lamp lights up.
Then the TIMER lamp goes off.
ON TIMER operation
l
Check that the clock is correct. If not, set the clock to the present
time (See page 40).
1
ON
Press while the air conditioner is
not operating.
AM
AM
blinks.
* Previous time setting
appears on display.
2
Press until the time setting
TIMER
reaches the point you like.
l
Every pressing of either button increases or decreases
the time setting by 10 minutes. Holding down either
button changes the setting rapidly.
3
Press once again.
ON
ON
OFF
AM
Then the TIMER lamp lights up.
n
To cancel the timer:
Press CANCEL .
Then the TIMER lamp goes off.
Combining ON TIMER and OFF TIMER
l
A sample setting for combining the two timers is shown below.
(Example)
Present time: 11:00 PM
(The unit operating)

OFF TIMER at 0:00 a.m.

Combined

ON TIMER at 7:00 a.m.
AM AM
Notes on ON,OFF TIMER
l
When TIMER is set, the present time is not displayed.
l
Once you set ON,OFF TIMER, the time setting is kept in the
memory. (The memory is canceled when remote controller
batteries are replaced.)
ATTENTION
n
In the following cases, set the timer again.
l
After a breaker has turned OFF.
l
After a power failure.
l
After replacing batteries in the remote controller.
SIE-86
is displayed.
11
(RE012)
System Configuration