Overview; General Considerations - Emerson 1410 Reference Manual

Reference Manual
00809-0200-4410, Rev BC
Section 3
Overview . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . page 13
Mounting . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . page 14
Remote antenna . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . page 15
Connections . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . page 17
Explosions could result in death or serious injury.
Verify the operating atmosphere of the device is consistent with the appropriate hazardous locations

certifications.
Electrostatic discharge can damage electronics.
Use proper personal grounding before handling electronics or making contact with leads and

terminals
Electrical shock could cause death or serious injury. If the device is installed in a high-voltage
environment and a fault condition or installation error occurs, high voltage may be present on
transmitter leads and terminals.
Use extreme caution when making contact with the leads and terminals.

Failure to follow these installation guidelines could result in death or serious injury.
Make sure only qualified personnel perform the installation.

This device complies with Part 15 of the FCC Rules. Operation is subject to the following
conditions:
This device may not cause harmful interference.

This device must accept any interference received, including interference that may cause undesired

operation.
This device must be installed to ensure a minimum antenna separation distance of 20 cm from all

persons.
3.1

Overview

This section describes how to properly mount the Emerson
make electrical connections, including electrical wiring, grounding, and host system connections. This
section also describes how to mount the optional remote antenna.
3.1.1

General considerations

The unit itself is not designed for outdoor mounting without a suitable enclosure. The Gateway should
be mounted in an approved electrical enclosure or building.
The Gateway should be mounted in a location that allows convenient access to the host system network
(process control network) as well as the wireless field device network and protects the Gateway from
moisture and contamination.
Installation
Mounting and Connection
Mounting and Connection
™
Wireless 1410 Gateway (Gateway) and
July 2017
13