Installing The Gateway; Emerson Gateway 1410S2 Installation Overview; Power Specifications - Emerson Rosemount 1410S Reference Manual

Reference Manual
00809-0600-4410
3

Installing the Gateway

3.1

Emerson Gateway 1410S2 installation overview

This section describes how to properly mount the Emerson 1410S2 Gateway and make
electrical connections including wiring, grounding, and host system connections.
General considerations
• Mount the Gateway in any general-purpose location.
• Ensure gasket between the Gateway cover and housing is in place and undamaged.
• Ensure cover is secured tightly to prevent exposure of any electronics to moisture and
contamination.
• Ensure cover is secured tightly and all used and unused wiring entries are sealed to
prevent exposure of electronics to any moisture or contamination.
• Mount the Gateway in a location allowing convenient access to the host system network
(process control network).
• Best practice is to install the Emerson 781S Smart Antennas centrally in the wireless
network for the most direct connections to the Gateway.
Physical description
For dimensional drawing information, refer to
Emerson 1410S2 Gateway electronics are enclosed in an aluminum housing. The conduit
entries in the enclosure have connections for power, Ethernet, serial and Emerson 781S
communications. The unit is designed to be modular and mountable to a pole or the Cisco
IW6300 Access Point.
3.2

Power specifications

Table 3-1: Emerson 1410S Gateway Power
Gateway version
Input voltage
Power consumption
Power over Ethernet (PoE)
Input and output connections
The Gateway is designed to be powered by 24 Vdc (nominal) Class 2 supply and requires
350 mA of current.
Emerson 1410S/781S
Reference
Non-barrier
10.5 to 30 Vdc
5 Watts
At start-up, the power supply must be capable of momentarily
sourcing at least twice the operating current. The Gateway may
draw significantly more current momentarily at start-up if not
limited by the power supply.
Gateway supports IEEE 802.11 PoE as a Powered Device (PD) on
either port.
In: DC power (2-wire, 1 connection)
Out: DC Power (2-wire, 2 connections)
I/O: RS-485 (2-wire, 2 connections)
Installing the Gateway
December 2023
data. The rugged modular
Barrier
24 Vdc
7.5 Watts
®
21