Connections And Power - Emerson 1410 Reference Manual

Reference Manual
00809-0200-4410, Rev BC
Table 2-1. Default IP Addresses
Ethernet 1
Ethernet 2
2.3.2

Connections and power

Physically connect the PC/laptop to the Gateway with an Ethernet cable by connecting one end to the
Ethernet port on the back of the PC/laptop. Connect the other end to the Ethernet 1 port on the
Gateway.
Gateway and PC/laptop are connected, wire a 24 VDC (nominal) power supply with a capacity of at least
250 mA to the Gateway power input terminals.
Figure 2-1. Wireless Gateway Housing Diagram
Power
Reset
A. DIN rail clip
B. SMA connector
C. Power and Reset indicator lights. During normal operation
the power indicator will be green. During a reset the reset
light will turn red. The reset switch should not be enabled
during normal operation.
D. Ethernet port 2. This secondary port must be enabled
when ordering to access the device. When this port is
activated, the factory IP address is 192.168.2.10.
See
Initial Connection
Gateway
192.168.1.10
192.168.2.10
"Configure the Gateway" on page 6
A
B
C
D
E
G
+
-
F
Table 2-1.
PC/laptop
192.168.1.12
192.168.2.12
shows the standard terminal block diagram. Once the
H
S
A B
E. Ethernet port 1. Use for standard
communication to the webserver or other
protocols enabled on the gateway. The factory
IP address is 192.168.1.10. See
F. Five screw terminal block.
G. 24 VDC (nominal) power input
H. Serial Modbus
Initial Connection
Subnet
255.255.255.0
255.255.255.0
Table 2-1.
®
July 2017
5