Rear Brake Pump - Combined - Gilera DNA 50 Workshop Manual

Braking system

Rear brake pump - combined

- Drain the brake fluid from the circuit using the bleed screw located on the calliper and operating the
brake lever until more fluid comes out.
- Remove the handlebar pump using the two stand set screws indicated in the figure.
- disconnect the hose and put the brake fluid in a container
- On refitting, perform the operation in reverse.
- Tighten the hydraulic line to the prescribed torque
and bleed the system.
Locking torques (N*m)
Brake fluid pump - hose fitting
BRAK SYS - 106
20 ÷ 25 Nm
DNA 50