At 60000 Km; Checkig The Spark Advance - Gilera DNA 50 Workshop Manual

Maintenance
Safety locks - check
Suspensions - check
Electrical system and battery - check
Headlight - adjustment
Tyre pressure and wear - check
SAS box (sponge) (**) - cleaning
Vehicle and brake test - road test
(**) See the regulations of the "Secondary air system" section
160'
Hub oil - change
Spark plug/electrode gap - replacement
Air filter - clean
Idling speed (*) - adjustment
Oil mixer/throttle linkage - adjustment
Driving belt - replacement
Variable speed rollers - replacement
Mixer belt - replacement
Coolant level - check
Radiator - external cleaning/ check
Odometer gear - greasing
Steering - adjustment
Brake control levers - greasing
Brake pads - check condition and wear
Flexible brake tubes - replacement
Brake fluid level - check
Transmission elements - lubrication
Safety locks - check
Suspensions - check
Electrical system and battery - check
Headlight - adjustment
Tyre pressure and wear - check
SAS box (sponge) (**) - cleaning
Vehicle and brake test - road test
(**) See the regulations of the "Secondary air system" section
Checking the spark advance
- Check to be effected at 4000 rpm with strobo-
scopic gun. The measured lead must be 17° be-
fore dead centre point.
- The rubber cap shown in the figure needs to be
removed before this check; this makes it possible
to see a reference mark in the magneto cover
N.B.
IN CASE OF MALFUNCTION, CARRY OUT THE CHECKS
PROVIDED FOR IN THE ELECTRICAL SYSTEM CHAPTER.
CAUTION
BEFORE CARRYING OUT THE ABOVE CHECKS, CHECK
THE CORRECT KEYING OF THE FLYWHEEL ON THE
CRANKSHAFT.
Specific tooling
020330Y Stroboscopic light to check timing
MAIN - 28
Action

AT 60000 KM

Action
DNA 50