Refitting The Hub Bearings; Refitting The Hub Cover - APRILIA SR MAX 125 ie Service Station Manual

SR MAX 125 ie
IF THE BEARING HAS AN ASYMMETRICAL BALL RETAINER, PLACE IT SO THAT THE BALLS
ARE VISIBLE FROM THE HUB INNER SIDE.
Specific tooling
020376Y Adapter handle
020359Y 42 x 47-mm adaptor
020363Y 20-mm guide
NOTE
WHEN FITTING THE BEARINGS ON THE ENGINE CRANKCASE, SUPPORT THE CRANKCASE
PREFERABLY ON A SURFACE TO ALLOW THE BEARINGS TO BE DRIVEN VERTICALLY.
- Refit the Seeger ring with the opening facing the bearing and fit a new oil seal flush with the crankcase
from the pulley side.

Refitting the hub bearings

- Install the three shafts in the engine crankcase
as shown in the figure.
Refitting the ub cover
- Fit a new gasket together with the alignment dowels.
- Seal the gasket of the breather pipe using black silicone sealant.
- Fit the gearbox cover, making sure the breather pipe is in the correct position.
- Position the shorter screw that can also be recognised from the different colour as shown in the figure.
Engine
ENG - 117