Installing A Printer Driver - Oki MC361dn User Manual

Connecting to a Computer
Click [Finish] to complete the
9
installation.
- To set a default printer, select the check box of the
driver you want.
- If the optional second unit is installed in the
machine prior to driver installation, click on
[Driver properties] and change the set tray.
Note
 If the dialog box prompting to restart the computer
appears, click [Yes]. The computer automatically
restarts.
Reference
 For how to configure the tray settings by the driver,
refer to "Printer Driver Configuration" P. 22.
Click [Start] > [Devices and Printers].
10
Check that the OKI MC561 icon is
11
displayed.
Right-click the OKI MC561 icon and select one of
the menu item, and then check that all the printer
drivers installed are displayed in the submenu.
Remove the "Software CD-ROM" from
12
the computer.
The installation is complete.
Installing a Printer Driver
(For Mac OS X)
To complete the network connection with a Mac
operating system, install a printer driver on the
computer and set your machine as a network
printer.
Select the protocol for your network connection
from the following:
 EtherTalk
 Bonjour (Rendezvous for Mac OS X 10.3)
Note
 EtherTalk is not supported in Mac OS X 10.6.
 Disable the anti-virus software before starting this
procedure.
 Using EtherTalk (For Mac OS X
10.5)
When connecting to the network with EtherTalk,
it is necessary to enable EtherTalk and disable
the sleep mode in the machine. Then, install the
driver in the computer.
 First, enable EtherTalk in the machine.
Ensure that your machine and the
1
computer are turned on and connected.
Reference
 "Connecting an Ethernet Cable" P. 31
Press the <SETTING> key on the
2
operator panel.
Press the
3
and press
Enter the administrator password.
4
The factory default password is "aaaaaa".
Select [Complete], and press
5
Press the
6
and press
Press the
7
and press
Press the
8
press .
OK
Press the
9
press .
OK
Press the
10
displayed.
 Next, disable the sleep mode in the machine.
Press the <SETTING> key on the
1
operator panel.
Press the
2
and press
Enter the administrator password.
3
The factory default password is "aaaaaa".
Select [Complete], and press
4
- 34 -
to select [Admin Setup],
.
OK
to select [Network Menu],
.
OK
to select [Network Setup],
.
OK
to select [EtherTalk], and
to select [Enable], and
until the top screen is
to select [Admin Setup],
.
OK
.
OK
.
OK