Table of Contents
Advertisement
Other Troubles
Symptom
It takes a while to start
printing.
The print result does not
change though you have
changed the [Density]
setting.
A print job has stopped
in the middle of the
printing process.
The specified settings
such as the time setting
have been erased.
Memory is insufficient.
It takes a long time to
finish printing.
The printer driver is not
correctly displayed on
Mac OS X.
Point to check
The machine is warming up from
the power save or sleep mode.
The machine may be cleaning the
image drum unit.
The machine is adjusting the
temperature of the fuser unit.
The machine is processing a data
from another interface.
You have also changed the [RGB
Adjustment] setting.
As a result of processing print jobs
continuously, the fuser unit has
become hot. The fuser unit is
cooling off.
As a result of processing print jobs
continuously for a long time, the
temperature in the machine inside
has become too high. The machine
is cooling off.
While color printing and color
copying, if using reading or
scanning mode for faxed
documents, all printing will stop
and then restart. This only
happens with MC561dn.
The machine was turned off for a
long time or every day.
You have been launched Multiple
applications.
The processing speed of the
computer may be slowing down
the print job.
You have selected [High Quality
(Multiple tones)] on the [Print
Job Options] tab of the printer
driver.
The print data is complicated.
When in reading or scanning mode
for faxed documents and color
printing or color copying, printing
will slow down. This only happens
with MC561dn.
The printer driver may not be
operating correctly.
Press the <SETTING> key and
select [Admin Setup] > [User
Install] > [Power Save Enable]/
[Sleep] and disable both modes.
Wait for a while.
Wait for a while.
Wait until the process finishes.
The [Density] setting is automati-
cally changed according to the
[RGB Adjustment] setting.
If the print result is not what you
expected, change the [RGB
Adjustment] setting again.
Wait for a while.
When the fuser unit gets cooler,
printing restarts automatically.
Wait for a while.
When the machine gets cooler,
printing restarts automatically.
The life of the battery may have
ended. Contact Oki Data's
customer support center.
Close the applications you are not
using.
Use a computer with faster
processing speed.
Select [Fine / Detail
(600x1200)] or [Normal
(600x600)] on the [Job
Options] tab of the printer driver.
Make the data simpler.
Uninstall the printer driver and
install it again.
- 158 -
Remedy
Reference
P.20
-
-
-
-
-
-
-
-
-
-
-
-
-
Advanced
Advertisement
Table of Contents
