Sleep Mode; Power Save Mode And Sleep Mode; Returning To The Standby Mode - Oki MC361dn User Manual

Installing Your Machine
When the screen prompting you to turn
4
off the power switch appears, press the
<O> (off) side of the power switch to
turn off the power switch.
Note
 Turn the power off, and when turning the power back on
again, push the power switch to the <|> side after waiting
for a few seconds.
 When the machine is not used for
long time
When the machine is not used for long time due
to holidays or trips, pull the power cord from the
socket. In addition, install the stopper release in
the fuser unit.
Memo
 The machine does not have functional failures if removing
the power plug for long time (more than 4 weeks).

Power Save Mode and Sleep Mode

The two-phase power saving mode enables you
to save the power consumption of the machine.
 Power Save Mode
When your machine is not used for a certain
period of time, it automatically enters a power
saving mode to reduce the power consumption.
You can enter the power saving mode manually
POWER SAVE
by pressing the <
operator panel.
POWER SAVE
The <
mode.
> key on the
> key lights up while in the
Memo
 By factory default, the time interval to enter the power
saving mode is set to 30 minutes. You can change the time
interval by pressing the <SETTING> key on the operator
panel and selecting [Admin Setup] > [Management] >
[Power Save] > [Power Save Time].
 Sleep Mode
Your machine goes from the power saving mode
into the sleep mode after a set period of time. In
the sleep mode, the status of your machine is
almost the same as when it is turned off.
The <POWER SAVE> key blinks while in the

sleep mode.

Note
 The machine does not enter the sleep mode if an error
occurs.
 If time-set transmission is scheduled, the machine will not
go into sleep mode.
 If the fax transmission is waiting for a redial, the machine
cannot enter sleep mode.
Memo
 By factory default, the time interval to enter the sleep
mode is set to 10 minutes. You can change the time
interval by pressing the <SETTING> key on the operator
panel and then selecting [Admin Setup] >
[Management] > [Power Save] > [Sleep Time].
Reference
 For more detailed information on sleep mode, please refer
to User's Manual Advanced.
 Returning to the Standby Mode
To return the machine to the standby mode from
the power saving or sleep modes, press the
<POWER SAVE> key on the operator panel.
Memo
 When your machine receives a print job from a computer
or other devices, it automatically returns to the standby
mode.
- 20 -