Clearing A Paper Misfeed - Toshiba e-STUDIO5506AC Hardware Troubleshooting Manual

1.TROUBLESHOOTING FOR THE HARDWARE
14. Hole Punch Unit (optional) ( P.33)
15. Saddle Stitch Unit (optional) ( P.36)
16. Finisher (optional) ( P.33)
The picture of the hardware device shown on the touch panel differs depending on the options installed.
 Clearing a paper misfeed
Remove the misfed paper from the bridge unit after you have cleared all the other misfeeds. Pulling out the bridge
unit from the equipment may tear the paper left inside the equipment.
1 Clear the paper misfeed.
Clear the paper misfeed following the guidance shown on the touch panel. Press
After clearing the misfeed, close all the opened covers.
2
The equipment starts the warm-up. Follow the guidance on the touch panel.
 Tips on removing the misfed paper
Note the following points in removing the misfed paper.
Remove the misfed paper from the bridge unit after clearing all the other misfeeds.
Remove the misfed paper from the bridge unit after you have cleared all the other misfeeds. If you pull out the bridge
unit from the equipment with the misfed paper left, the misfed paper may be torn and left inside the equipment.
Remove the misfed paper carefully so as not to tear it.
To avoid tearing the misfed paper, remove the paper slowly with both hands. Using force may tear the paper, making
it more difficult to remove. See also that no pieces of torn paper are left inside the equipment.
When the paper misfeed sign remains after removing the misfed paper:
Depending on the timing of the occurrence, no misfed paper may be found where the paper misfeed sign indicates. If
the sign does not disappear after you have removed the misfed paper, follow the steps as instructed on the touch
panel.
Do not touch the connectors inside the equipment.
This could cause a malfunction.
or to scroll the pages.

Clearing a Paper Misfeed 19