Toshiba e-STUDIO5506AC Hardware Troubleshooting Manual page 13

1.TROUBLESHOOTING FOR THE HARDWARE
Message
Change direction of original
Time for Developer (*)
Maintenance.
(The colors are shown
abbreviated: Y: yellow, M:
magenta, C: cyan and K: black.)
Cannot print this paper size
Select the other drawer.
Cannot print this paper type
Set the other paper type
Change from this mode
Count over, cannot store
anymore
Ready(*** Toner Not
Recognized)
Check the toner cartridge
Ready (Saddle Stitch Tray Full)
Ready (Check Saddle Stitch
Stapler)
Ready (Check Saddle Stitch
Stapler)
Ready (Check Stapler)
Problem Description
The orientation of the original
placed on the original glass is
incorrect.
Little developer remains. "*"
indicates the color of the
developer.
Printing was attempted but
failed. The paper could not be
output on the tray selected for
the paper output because of a
mismatch between the paper
size and the tray.
Printing was attempted but
failed.
The paper could not be output
in the tray selected because of a
mismatch between the paper
type and the tray.
(Special paper or thick 4 paper
tried to be output on the lower
receiving tray of MJ-1111/
MJ-1112.)
The number of originals to be
scanned has exceeded the limit
specified with the department
or user code during scanning.
The toner cartridge indicated by
*** is not installed at all or
improperly so.
The terminal of the toner
cartridge is stained.
The recommended toner
cartridge is not being used.
The saddle stitch tray of the
finisher is full of paper.
A staple jam has occurred in the
stapler of the saddle stitch unit
or the staple sheet has not been
fed sufficiently.
Staples in the stapler of the
saddle stitch unit have almost
run out or have actually done
so.
Staple jam has occurred in the
stapler of the finisher.
Corrective Action
Change the orientation of the original by 90
degrees and place it on the original glass.
Contact your service representative.
Delete the failed print job, select the
appropriate tray for the paper, and perform
printing again.
For the restrictions of the paper type and the
receiving trays, refer to the Quick Start Guide.
Delete the failed print job, select the
appropriate tray for the paper, and perform
printing again.
Ask your administrator for details of setting
the limit for the number of copies.
Install the toner cartridge correctly.
 P.55 "Replacing a Toner Cartridge"
Wipe the terminal with a soft cloth.
Use the recommended toner cartridge.
 P.55 "Replacing a Toner Cartridge"
Remove the paper from the saddle stitch tray
of the finisher.
Remove the top staple sheet.
 P.53 "Saddle Stitch unit"
Replace the staple case of the saddle stitch
unit if stapling is not performed for an output
document even though the stapling function
has been selected.
 P.66 "Saddle Stitch unit"
Remove the jammed staples.
 P.51 "Clearing a Staple Jam"
Messages Displayed on the Touch Panel 13