Presser Foot Lever - Siruba HSM-2517 Instructions Manual

1
2
4
F
5
4
3
-
2
S
1
+
3
6
1.ADJUSTING TOP THREAD TENSION
Decrease or increase the tension of the top thread by
using this control.
The higher the number,the tighter the tension.

2.PRESSER FOOT LEVER

There are three positions for your presser foot.
1.Lower the presser foot to sew.
2.Raise the lever to the middle position to insert or remoye
fabric.
3.Lift it to its highest position to change the presser foot or
to remove thick fabric.
3.STITCH WIDTH / NEEDLE POSITION DIAL
The width of all the stitches produced on this machine can be
made narrower or wider by adjusting the stitch width control.
When sewing straight stitching, you can select various needle
positions from 0 (right needle position) to 5 (left needle position)
with the same control dial. The triangle marking between 2 and 3
shows the center position.
4.STITCH SELECTOR AND INDICATOR
1.To select a stitch, be sure needle is out of fabric at its highest
position.
2.Then turn the selector until the required stitch is indicated on
the indicator
panel.
5.STITCH LENGTH / SUPER (STRETCH) STITCH DIAL
Stitch length can be selected easily according to thickness
and type of fabric.
Super (stretch) stitch patterns can be selected by turning the same
dial
to S mark where fine adjustment can be made.
6.REVERSE STITCH LEVER
It is recommended to begin, or end seams with several stitches
in reverse
for reinforcement. As long as you are pressing down this lever
while sewing, the machine will continue to feed the fabric
backwards.
-10-