Zigzag Stitching; Satin Stitch; Blind Stitch - Siruba HSM-2517 Instructions Manual

ZIGZAG STITCHING

Stitch Selector B
Stitch Width 1-5
Stitch Length 1-4
Stitch length
0.5-1 1 2

BLIND STITCH

Stitch Selector C,F
Stitch Width 1-5
Stitch Length 1-4
1.First finish the hem edge(for lightweight fabric,press 1/4
inch to the wrong side,for heavier fabric,use multiple zig
zag to overcast the edge).Figure 1.
2.Press the hem in place.Fold the hem toward the right
side leaving about 1/4 inch of the wrong side of the hem
edge extending.Figure 2.
3.Place the wrong side of the garment under the blind hem
presser foot with the extension to the right and the fold
of the hem against the guide in the foot as illustrated in
figure 3.Turn the hand wheel to take a few stitches and
turn the screw on the foot to adjust the guide so the s-
titch just catches the fold.
4.Press both sides of the finished hem.The right side should
barely show the stitches.
Stitch indicator
B
Thread tension dial
Under side
3 4
Top side
C F

SATIN STITCH

This is a closely spaced attractive stitch used for
applique,bar-tacking,etc. Slightly loosen top thread
tension for satin stitching.
Use a backing stabilizer interfacing for the sheer
materials to avoid puckering.
1
0
(Fig.1)
-16-
The top thread may appear
on the under side depending
on the thread, fabric and
sewing speed, but the bobbin
thread must never appear on
the top of the fabric.
(Fig.2)
(Fig.3)
(Fig.4)