Adjusting The Presser Foot - Siruba NC008 Instruction Book

3. 調整針的前後位置時，請拆下橡膠塞 (E)，鬆
開擺針棒 (F) 的固定螺絲 (G)，進行前後移動
調整。( 圖 36)
4. 針的前後運動量調整：要調整針與送具相對
運動量時，請拆下下座之後蓋 (H) 及防油墊
片 (I)，鬆開針擺棒銷 (J) 的螺帽 (K)，上下移
動進行調整。
* 向上移動，針的運動量比送具大 ; 向下移動
則針的運動量比送具小。( 圖 37)
壓腳的調整
1. 壓腳壓力的調整 :
旋鈕 (A) 順時針方向旋轉壓力增大，逆時針
方向旋轉壓力減小。( 圖 38)
2. 壓腳最大高度為 9mm。( 圖 39)
圖 36/Fig 36
3.Remove the rubber plug (E) of the machine.
4.Adjusting of front-back movement amount of
*The needle feeding amount is increased

ADJUSTING THE PRESSER FOOT

圖 38/Fig 38
1.Presser foot pressure :
2.The maximum height of the presser foot
Introduction
Adjust the needle clamp with the moving to
front and back after loosening of the screw
(G) of the needle swing lever arm (F).
(Fig 36)
the needle : when adjusting of the movement
amount of the needle, remove the cover (H)
and the gasket (I),moving up and down of
the needle swing lever pin (J) after loosening
of the nut (K).
when moving up. The needle feeding amount
is decreased when moving down. (Fig 37)
To increase the presser foot pressure, turn
the adjusting knob clockwise. (Fig 38)
approximately 9mm. (Fig 39)
圖 37/Fig 37
圖 39/Fig 39
P20