Straight Stitches - Siruba HSM-2517 Instructions Manual

STRAIGHT STITCHES

A
Stitch Selector
Stitch Width 2-3
3
Stitch Length
Straight stitch most frequently used for every aspect of sewing.Learn the correct method of your
machine following the steps below.
1
A B C
J I
2
3
5
1
1.SETTINGS
D
Stitch indicator - A
Stitch length - 2 - 3
F
Thread tension - 3
Raise the take-up lever to its
E
highest position by turning the
hand wheel toward you.
Take-up lever
A
G
Tension dial
B
H
Stitch width/needle
C
position dial
Stitch indicator
D
Stitch selector
E
Hand wheel
F
4
Stitch lendth dial
G
Power/light switch
H
Reverse stitch lever
I
Presser foot lever
J
6
2
5. a. Start to sew stepping on the foot control.
6. a. Turn the hand wheel to raise the needle.
Needle position for straight stitching
Straight stitch at left needle position with needle position
1
control at L.
Straight stitch at middle needle position with needle
2
position control set at M.
Straight stitch at right needle position with needle
3
position control at R.
3
-9-
2.Pull both threads under the
presser foot toward the back
of the machine.
3.Place the fabric under the
presser foot and lower the
presser foot lever.
4.Turn the hand wheel toward
you until the needle enters the
fabric.
b. Guide the fabric gently with your hand.
c. When you reach the end of the fabric, stop the
machine by releasing the foot control.
b. Raise the presser foot by pushing the lever up.
c. Use the thread cutter above the presser foot to
cut off excess threads.
d. Pull both threads under and to the back of the
presser foot, leaving 4 inches (10cm) thread tail.