Table of Contents
Advertisement
Powering on the system
1.
Cord retainer
DANGER
If the installation requires a different power cord than the one supplied with the device, make sure you use a
power cord displaying the mark of the safety agency that defines the regulations for power cords in your country.
The mark is your assurance that the power cord can be used safely with the device.
4.
Connect the power cord to the wall outlet.
5.
Observe the LEDs on the power supply front panel. The AC OK and DC OK LEDs should be green (steady), which indicates the
power supply is providing power to the components. If it is amber or OFF, the power supply is not providing power to the
components. The ALM LED should be OFF.
Connecting DC power to the chassis
You can use a DC power source for the Brocade chassis using a DC-to-DC power supply. DC power must be supplied at 48 V and 30
A.
To perform this task, you need the following items:
•
Flathead screwdriver
•
Phillips-head screwdriver
•
#6 AWG wire (grounding wire)
•
#8 AWG wire (input wire)
•
Crimping tool
70
Brocade FastIron SX Series Chassis Hardware Installation Guide
Part Number: 53-1003613-04
Advertisement
Table of Contents
