Table of Contents
Advertisement
Installing or replacing a power supply
To install a copper or fiber optic module, perform the following tasks.
1.
Put on the ESD wrist strap and ground yourself by inserting the plug into the ESD connector located in the lower right corner of
the chassis front.
2.
Remove the new module from its protective packaging.
3.
Gently insert the copper or fiber optic module into the port until the module clicks into place. The module is keyed to prevent
incorrect insertion.
Cabling a fiber optic module
To cable a fiber optic module, perform the following tasks.
1.
Remove the protective covering from the fiber-optic port connectors and store the covering for future use.
2.
Before cabling a fiber optic module, Brocade strongly recommends cleaning the cable connectors and the port connectors. For
more information, refer to
3.
Gently insert the cable connector or connectors (a tab on each connector should face upward) into the port connector or
connectors until the tabs lock into place.
4.
Observe the link and active LEDs to determine if the network connections are functioning properly. For more information about
the LED indicators, refer to
Installing or replacing a power supply
DANGER
Before beginning the installation, see the precautions in "Power precautions."
This section provides information about the following topics:
•
Determining which power supply has failed, if necessary
•
Replacing an AC power supply
•
Replacing a DC power supply
•
Connecting power to the chassis
•
Verifying proper operation
Determining which power supply failed
To determine which power supply has failed, enter the following command at any CLI command prompt.
# show chassis
device
This command displays status information for the power supplies, as well as information for the fans, and temperature readings for
various components in the chassis. The power supplies are numbered in the display. "Power 1" indicates the power supply installed in
power supply slot 1, "power 2" indicates the power supply installed in slot 2, and so on. The two figures below show the power supply
slot numbers.
If the display indicates "Installed (Failed)" for any of the slots, the power supply installed in that particular slot has failed.
134
Cleaning the fiber optic connectors
Observing LEDs
on page 92.
on page 119.
Brocade FastIron SX Series Chassis Hardware Installation Guide
Part Number: 53-1003613-04
Advertisement
Table of Contents
