Table of Contents
Advertisement
Attaching a management station
FIGURE 30 Installing an SX-FI48GPP POE+ interface module in an FSX 1600 device
Attaching a management station
You can manage the FastIron X Series system in the following ways:
•
Connect a PC or terminal to the serial (Console) port or 10/100/1000 Ethernet port on the management module and access
the system directly or through a Telnet connection to the PC or terminal. See the task below.
•
Connect the FastIron X Series switch to your existing management network and manage the switch, along with other network
devices, from a management station. To do this, you can connect a switch to a Gigabit Ethernet port on the management
module. Refer to
Attaching a switch to an Ethernet port
NOTE
The management network into which you can connect a Gigabit Ethernet port must be separate and isolated from the network
over which user packets are switched and routed.
62
on page 63.
Brocade FastIron SX Series Chassis Hardware Installation Guide
Part Number: 53-1003613-04
Advertisement
Table of Contents
