Table of Contents
Advertisement
Hardware components
Switch fabric modules
Switch fabric modules switch user packets from one interface module to another. Switch fabric modules in the FSX 800 and FSX 1600
devices are separate and are located next to the management modules in the device.
Switch fabric modules
shows an FSX 800 and FSX 1600 switch fabric module front panel.
FIGURE 7 FSX 800 and FSX 1600 switch fabric module front panel
Switch fabric module LEDs
The front panel provides status information through the LEDs listed in the table below.
TABLE 4 Switch fabric module LEDs
LED
Pwr
Active
Interface modules
This section describes interface modules for the FastIron X Series chassis devices. The following installation rules apply:
•
In the FSX 800 device, you can install up to eight single slot and four double interface modules in the slots shown in
chassis
on page 15.
•
In the FSX 1600 device, you can install up to 16 single slot and eight double slot interface modules in the slots shown in
1600 chassis
on page 17.
NOTE
You cannot mix Second Generation and Third Generation modules in the same device.
The table below lists the supported interface modules for each FastIron X Series chassis device type.
TABLE 5 Interface modules
Interface Module
Second Generation Interface Modules
24-port Gigabit Ethernet copper
without PoE
24-port Gigabit Ethernet copper
with PoE
24
Description and Position
Top LED
Bottom LED
Part Number
SX-FI624C
SX-FI624P
State
On (Green)
Off
On (Green)
Off
FSX 800
X
X
Brocade FastIron SX Series Chassis Hardware Installation Guide
Meaning
The module is receiving power.
The module is not receiving power.
The module is functioning properly.
The module is not functioning
properly.
FSX 800
FSX 1600
X
X
Part Number: 53-1003613-04
FSX
Advertisement
Table of Contents
