Disabling And Re-Enabling An Interface Module - Brocade Communications Systems FastIron SX Hardware Installation Manual

FIGURE 51 Installing an interface module in the FSX 1600 chassis
1. Interface module

Disabling and re-enabling an interface module

NOTE
This section does not apply to the active management module. The disable module and enable module commands are not
applicable to the active management module. If you attempt to remove the management module while the chassis is powered
on and running, all traffic being handled by the system will stop.
Brocade FastIron SX Series Chassis Hardware Installation Guide
Part Number: 53-1003613-04
Replacing an interface module
131