Removing A Dc Power Supply - Brocade Communications Systems FastIron SX Hardware Installation Manual

To remove an original AC power supply, perform the following tasks.
1. Disconnect the power supply's power cord from the wall outlet.
2. Disconnect the power cord from the chassis rear panel.
3. Release the latch on the front of the power supply to unlock the power supply from its position in the chassis:
• – Locate the 1/2 in tab (latch release) on the bottom center of the front of the power supply.
– Firmly press on the latch release.
– The latch should spring open.
– Gently push the latch to the right.
4. Gently pull on the power supply latch until the power supply is removed from the chassis.
5. Install a new power supply in the slot. For information about performing this task, refer to the "Installing a new power supply"
section.

Removing a DC power supply

You can order a new DC power supply from Brocade Communication Systems, Inc.
The power supplies are hot swappable, which means they can be removed and replaced while the chassis is powered on and running.
Brocade FastIron SX Series Chassis Hardware Installation Guide
Part Number: 53-1003613-04
Installing or replacing a power supply
137