Table of Contents
Advertisement
3.
Start by mounting the chassis that goes in the lowest position in the rack. With two or more people lifting the chassis, slip the
wide portion of each keyhole slot over the corresponding screw in the rack.
FIGURE 23 Mounting a chassis in a rack - front mount
4.
Slide the chassis down so that the screw heads are in the narrow portion of the keyhole slots.
5.
Install the remaining two mounting screws through the opposite corners of the brackets into the rack.
6.
Tighten all screws to secure the chassis in place.
7.
Repeat Step 2 through Step 6 to mount each subsequent chassis in the same rack.
Installing mounting brackets on the FSX 1600 chassis
The FSX 1600 chassis does not ship with mounting brackets installed. You will need to install the brackets, using a #2 Phillips or
flathead screwdriver. Mount the brackets as shown in the figure below. Since the brackets are identical, you must rotate one bracket 90
degrees to fit on the opposite side from the first bracket.
Brocade FastIron SX Series Chassis Hardware Installation Guide
Part Number: 53-1003613-04
Installing the chassis in a rack
53
Advertisement
Table of Contents
