Power Cords - Brocade Communications Systems FastIron SX Hardware Installation Manual

Powering on the system
NOTE
If the wall outlet is not rated 115 or 120V and 20A, stop and get the appropriate cable for the outlet. Make sure you obtain a
power cord displaying the mark of the safety agency that defines the regulations for power cords in your country. The mark is
your assurance that the power cord can be used safely with the device.
NOTE
The wall outlet should be installed near the equipment and should be easily accessible.
NOTE
The FastIron X Series switch is designed to provide uninterrupted service even when you insert or remove the interface
modules. Therefore, the system does not have a separate on or off power switch. To turn the system off, simply unplug the

power cords.

DANGER
High Touch Current. Earth connection essential before connecting supply.
Power cords
All of the FastIron devices ship with US-compatible power cords unless otherwise specified at the time of order. United Kingdom- and
European-compatible power cords are also available.
Input connector and plug
In AC deployments, the power cords plug into the rear of the chassis using C20 inputs. The AC power supplies are installed in the front
of the chassis and receive power from the inputs on the back.
In DC deployments, a two-position terminal block is located on the power supply itself, and DC power is wired on the front of the chassis.
TABLE 18 Input connectors for AC and DC power supplies
Power Supplies
SX-ACPWR-SYS
SX-ACPWR-POE
SX-ACPWR2500-POE
SX-DCPWR-SYS
SX-DCPWR-POE
The figure below shows the power plug configuration for the male and female end of the cable for the SX-ACPWR-SYS and SX-
ACPWR-POE power supplies. The power cord is 2.5 meters in length.
64
AC Input Connector Properties
Standard IEC type (IEC320)
C20 type: UL/CSA 20A/250V, VDE 16A/250V
Orientation: Ground pin down
2-position terminal block
The power supply is connected to Earth Ground through the power supply
chassis.
Brocade FastIron SX Series Chassis Hardware Installation Guide
Part Number: 53-1003613-04