Installing FastIron SX Devices
•
Unpacking the system..................................................................................................................................................................................... 47
•
Installation precautions.................................................................................................................................................................................... 48
•
Preparing the installation site........................................................................................................................................................................ 50
•
•
Installing the chassis in a rack.......................................................................................................................................................................51
•
Removing the slot panels...............................................................................................................................................................................55
•
•
Attaching a management station................................................................................................................................................................ 62
•
Powering on the system................................................................................................................................................................................. 63
•
Verifying proper operation............................................................................................................................................................................. 75
This chapter describes how to install your FastIron SX devices.
DANGER
Information about configuring IP addresses and connecting a FastIron SX chassis device to other network devices is covered in
the "Connecting Network Devices and Checking Connectivity" section.
Unpacking the system
FastIron SX devices ship with the following items. Review this list and verify the contents:
NOTE
If any items are missing, contact the place of purchase.
•
FastIron SX chassis with the following components installed:
-
One or two 12-volt power supplies
-
Fan tray assembly or assemblies
-
Slot panels installed in all unoccupied slots
-
Two switch fabric modules installed
•
Rack Mount Kit (FSX 1600 models only)
•
Management module or modules (packaged separately)
•
Optional interface modules (packaged separately)
•
Warranty card
•
A 115V AC power cable for each AC power supply you purchase from Brocade
DANGER
If the installation requires a different power cord than the one supplied with the device, make sure you use a power cord
displaying the mark of the safety agency that defines the regulations for power cords in your country. The mark is your
assurance that the power cord can be used safely with the device.
Brocade FastIron SX Series Chassis Hardware Installation Guide
Part Number: 53-1003613-04
47