Temperature Value (Command : D N); Lamp Fault Check (Command : D P) - HP LD4201 User Manual

Transmission
[d][l][][Set ID][][Data][x]
[Data]
Acknowledgement
[l][][Set ID][][OK/NG][Data][x]
[Data]

31. Temperature value (Command : d n)

To read the inside temperature value.
Transmission
[d][n][][Set ID][][Data][x]
[Data]
Acknowledgement
[n][][Set ID][][OK/NG][Data][x]
[Data]

32. Lamp fault Check (Command : d p)

To check lamp fault.
Transmission
[d][p][][Set ID][][Data][x]
ENWW
2nd Draft
Data is always FF (in Hex)
The data means used hours.
(Hexadecimal code)
Data is always FF (in Hex)
The data is 1 byte long in Hexadecimal.
Transmission/Receiving Protocol
115