Removing The Ds4400 Storage Server Bezel; Replacing The Ds4400 Storage Server Bezel - IBM TotalStorage DS4400 User Manual

Attention: Pulling the cover out too far can damage the plastic hooks at the top.
To avoid damaging the hooks, place the DS4400 Storage Server on a flat surface.
Be sure the front of the DS4400 Storage Server extends beyond the edge
approximately 5 cm (2 in.).
1. Carefully pull the bottom of the bezel out to release the pins; then slide the
bezel down, as shown in Figure 21.
DS4400 bezel
Figure 21. Removing the DS4400 Storage Server bezel
2. To replace the bezel, slip the top edge of the bezel under the lip on the chassis,
then push the bottom of the bezel until the pins snap into the mounting holes,
as shown in Figure 22.
DS4400 bezel
Figure 22. Replacing the DS4400 Storage Server bezel
Chapter 2. Operating the DS4400 Storage Server
23