Setting Presets And Sequences; Re-Recording A Preset - ETC ColorSource PAR Installation Manual

ETC Installation Guide
ColorSource PAR v1.5

Setting presets and sequences

There are twelve factory-configured presets followed by five factory-
configured sequences built into the fixture. From the Preset/Sequence menu,
press the Up and Down buttons to scroll through the list. The sequence or
preset plays immediately upon selection. All presets and sequences can be re-
recorded through an RDM device.

Re-recording a preset

1:
2:
3:
4:
Note: When the fixture is in Direct mode (
It is possible to activate a known preset or sequence from a connected fixture
when DMX is not present. If a connected fixture activates a preset or
sequence that is not recognized by the PAR, the PAR will hold its last look.
When DMX is restored, the DMX takes priority.
ColorSource PAR v1.5
Using DMX or RDM, set the desired RGB levels.
Press the Mode button to access the Preset/Sequence menu.
Using the Up and Down buttons, navigate to the preset number that
you want to re-record.
Hold the Mode button for 3 seconds to confirm the preset selection.
The user interface will show a 3-second countdown. The preset
number blinks once to confirm that the preset has been recorded.

mode (
When you re-record presets with the fixture in RGB

mode (
turned off.
See
Changing the DMX control mode
), you cannot re-record presets.
), the intensity is set to full and the strobe is
Page 6 of 12

) or 1-channel
on
page 8.
ETC