Juniper EX9200 Features Manual page 405
Port mirroring feature guide ex series
Hide thumbs
Also See for EX9200:
- Features manual (342 pages) ,
- Manual (118 pages) ,
- Overview manual (72 pages)
Table of Contents
Advertisement
Copyright © 2016, Juniper Networks, Inc.
Chapter 13: Operational Commands: Packet Forwarding Engine Components
EX8208 switches—Replace
card).
EX8216 switches—Replace
card).
QFX Series:
QFX3500,QFX3600, QFX5100, and OCX Series standalone switches—Replace
with 0. In the command output, FPC refers to a line card. The FPC
slot-number
number equals the slot number for the line card.
QFabric systems—Replace
the command output, FPC refers to a line card. The FPC number equals the slot
number for the line card.
—(MX Series routers and EX Series switches only) (Optional) Display PIC
all-members
information for all member routers in the Virtual Chassis configuration.
—(QFabric systems only) (Optional) Display PIC information
interconnect-device name
for a specified Interconnect device.
lcc number
—(TX Matrix and TX Matrix Plus routers only) (Optional) On a TX Matrix router,
display PIC information for a specified T640 router (or line-card chassis) that is
connected to the TX Matrix router. On a TX Matrix Plus router, display PIC information
for a specified router (line-card chassis) that is connected to the TX Matrix Plus
router.
Replace number with the following values depending on the LCC configuration:
0 through 3, when T640 routers are connected to a TX Matrix router in a routing
matrix.
0 through 3, when T1600 routers are connected to a TX Matrix Plus router in a
routing matrix.
0 through 7, when T1600 routers are connected to a TX Matrix Plus router with 3D
SIBs in a routing matrix.
0, 2, 4, or 6, when T4000 routers are connected to a TX Matrix Plus router with
3D SIBs in a routing matrix.
—(MX Series routers and EX Series switches only) (Optional) Display PIC information
local
for the local Virtual Chassis member.
—(MX Series routers and EX Series switches only) (Optional) Display
member member-id
PIC information for the specified member of the Virtual Chassis configuration. Replace
with a value of 0 or 1.
member-id
—(QFabric systems only) (Optional) Display PIC information for a
node-device name
specified Node device.
pic-slot slot-number
—Display information about the PIC in this particular PIC slot. For
routers, replace
slot-number
with a value from 0 through 7 (line
slot-number
slot-number
with a value from 0 through 15 (line
slot-number
with any number between 0 and 15. In
with a value from
through
0
. For EX3200 and EX4200
3
389
Advertisement
Table of Contents
