Juniper EX9200 Features Manual page 38

Port Mirroring Feature Guide for EX9200 Switches
22
Specify global-level packet-selection properties.
3.
Specify the number of packets to select:
a.
[edit forwarding-options port-mirroring input]
user@host# set rate number
The valid range is through
1
Specify the number of packets to mirror from each selection:
b.
[edit forwarding-options port-mirroring input]
user@host# set run-length number
The valid range is 0
Specify the length to which mirrored packets are to be truncated:
c.
[edit forwarding-options port-mirroring input]
user@host# set maximum-packet-length number
The valid range is through
0
packets are not truncated.
Specify the global-level Layer 2 address-type family from which traffic is to be selected
4.
for mirroring:
[edit forwarding-options port-mirroring input]
user@host# up
[edit forwarding-options port-mirroring]
user@host# edit family family
The value of the family option can be
NOTE: Under the
the protocol family statement
. The command-line interface (CLI) displays Layer 2
family vpls
port-mirroring configurations as
configured as
when the physical interface is configured with
ethernet-bridge
Enable configuration of global-level mirror destination properties for this address
5.
family:
[edit forwarding-options port-mirroring family family]
user@host# edit output
.
65535
through 20 . The default value is
. The default value is
9216
ethernet-switching
[edit forwarding-options port-mirroring]
family ethernet-switching
family vpls
family ethernet-switching
.
0 .
, which means the mirrored
0
, ccc , or vpls .
hierarchy level,
is an alias for
, even for Layer 2 port-mirroring
. Use family ethernet-switching
encapsulation
Copyright © 2016, Juniper Networks, Inc.