Juniper EX9200 Features Manual page 219

Options
Copyright © 2016, Juniper Networks, Inc.
Chapter 13: Operational Commands: Packet Forwarding Engine Components
In the EX Series switch command output, FPC refers to the following:
On EX2200 switches, EX3200 switches, EX4200 standalone switches, and EX4500
switches—Refers to the switch; FPC number is always 0.
On EX4200 switches in a Virtual Chassis configuration—Refers to the member of a
Virtual Chassis; FPC number equals the member ID, from 0 through 9.
On EX8208 and EX8216 switches—Refers to a line card; FPC number equals the slot
number for the line card.
On QFX3500, QFX5100, and OCX Series standalone switches, both the FPC and FPC
number are always .
0
On T4000 Type 5 FPCs, there are no
parameters. Instead,
sensor
parameters are displayed.
sensors
Starting from Junos OS Release 11.4, the output of the
operational mode command displays the enhanced midplanes FRU model numbers
(CHAS-BP3-MX240-S, CHAS-BP3-MX480-S or CHAS-BP3-MX960-S) based on the
router. Prior to release 11.4, the FRU model numbers are left blank when the router has
enhanced midplanes. Note that the enhanced midplanes are introduced through the
Junos OS Release 13.3, but can be supported on all Junos OS releases.
Starting with Junos OS Release 14.1, the output of the
extensive | clei-models | models
supply module (PSM) and power distribution unit (PDU) that are added to provide power
to the high-density FPC (FPC2-PTX-P1A) and other components in a PTX5000 Packet
Transport Router.
—Display information about hardware. For a TX Matrix router, display information
none
about the TX Matrix router and its attached T640 routers. For a TX Matrix Plus router,
display information about the TX Matrix Plus router and its attached routers.
clei-models —(Optional) Display Common Language Equipment Identifier (CLEI) barcode
and model number for orderable field-replaceable units (FRUs).
—(Optional) Include RAM and disk information in output.
detail
—(Optional) Display ID EEPROM information.
extensive
—(MX Series routers only) (Optional) Display hardware-specific information
all-members
for all the members of the Virtual Chassis configuration.
—(QFabric systems only) (Optional) Display hardware-specific
interconnect-device name
information for the Interconnect device.
lcc number —(TX Matrix routers and TX Matrix Plus router only) (Optional) On a TX Matrix
router, display hardware information for a specified T640 router (line-card chassis)
that is connected to the TX Matrix router. On a TX Matrix Plus router, display hardware
information for a specified router (line-card chassis) that is connected to the
TX Matrix Plus router.
top temperature sensor
fan intake temperature sensor
show chassis hardware detail |
operational mode command displays the new DC power
or bottom temperature
and
fan exhaust temperature
show chassis hardware models
203