Juniper EX9200 Features Manual page 105

Verification
Purpose
Action
Meaning
Related
Documentation
Copyright © 2016, Juniper Networks, Inc.
ge-0/0/5 {
unit 0 {
family ethernet-switching {
interface-mode access;
vlan {
members remote-analyzer;
}
}
}
}
}
To confirm that the configuration is working properly, perform these tasks:
Verifying That the Port-Mirroring Instance Has Been Correctly Created on page 89
Verifying That the Port-Mirroring Instance Has Been Correctly Created
Verify that the port-mirror instance
switch with the appropriate output VLAN.
You can verify that the port-mirror is configured as expected by using the
forwarding-options port-mirror
disabled, go to the J-Web interface.
To verify that the port-mirror is configured as expected while monitoring employee traffic
on the source switch, run the
switch. The following output is displayed for this configuration example:
user@switch> show forwarding-options port-mirror
Instance Name: employee-web-monitor
Instance Id: 3
Input parameters:
Rate
Run-length
Maximum-packet-length : 0
Output parameters:
Family
ethernet-switching
This output shows that the
every packet, which is the default), the maximum size of the original packet that was
mirrored (0 indicates the entire packet), the state of the configuration is up (which
indicates the proper state and that the analyzer is programmed, is mirroring the traffic
entering ge-0/0/0 and ge-0/0/1, and is sending the mirrored traffic to the VLAN called
).
remote-analyzer
Layer 2 Port Mirroring to Remote Destination by Using Destination as VLAN on page 81
Chapter 9: Port Mirroring for Remote Destinations
employee-web-monitor
command. To view previously created analyzers that are
show forwarding-options port-miror
: 1
: 0
State Destination
up default-switch/remote-analyzer
employee-web-monitor instance has a ratio of 1 (mirroring
has been created on the
show
command on the source
Next-hop
89