Chapter 3
Installing
Installing the Interface Module
Before installing the interface module, read the Activating or Deactivating Interface Module section
Note
in the
Before inserting an interface module, make sure that the chassis is grounded.
Step 1
If present, remove the blank filler plate covering the interface module slot. To remove, pull the blank
Step 2
filler plate completely out of the router slot using the captive screws.
To insert the interface module, carefully align the edges of the interface module between the upper and
Step 3
lower edges of the interface module slot in the router.
Step 4
Carefully slide the interface module into the router slot until the interface module makes contact with
the backplane.
Router.
Figure 3-14
Tighten the locking thumbscrews on both sides of the interface module. The recommended maximum
Step 5
torque is 5.5 in.-lb (.62 N-m).
Cisco ASR-920-24SZ-IM, ASR-920-24SZ-M, ASR-920-24TZ-M Aggregation Services Router Hardware Installation Guide
Cisco ASR 920 Series Aggregation Services Router Configuration
Figure 3-14
shows how to install the interface module on Cisco ASR-920-24SZ-IM
Inserting an Interface Module on Cisco ASR-920-24SZ-IM Router
Installing and Removing the Interface Module
Guide.
3-19