Chapter 3
Installing
Attaching the Cable Guides
The Cisco ASR-920-24SZ-IM Router supports the following cable guides:
•
If the chassis is mounted using 19-inch brackets, you must assemble the cable guides before installing
Note
the chassis on the rack.
To install the cable guides, perform these steps:
Position the cable guide-left and cable guide-right against the front of the chassis and align the four
Step 1
screw holes, as shown in
Secure the cable guides with the four M6x12mm screws supplied with the cable kit. The recommended
Step 2
maximum torque is 3N-m.
Figure 3-9
Cable Guide Installation On Cisco ASR-920-24SZ-IM Router For 19-inch Rack Brackets
Cisco ASR-920-24SZ-IM, ASR-920-24SZ-M, ASR-920-24TZ-M Aggregation Services Router Hardware Installation Guide
A920-CBL-GUIDE (left and right)—help in routing the cables from all components on the front
panel thereby enabling a proper cable-bending radius.
Figure 3-9
for 19-inch rack and
Figure 3-10
Installing the Router in a Rack
for other racks using standard kit.
3-13