Cpu Management Port Leds - Cisco ASR-920-24SZ-IM Installation Manual

Cisco ASR 920 Series Routers Features
Table 1-5 PWR and STAT LED Indications
PWR LED State STAT LED state
Amber Off
Amber Red
Flashing Amber and Amber
Green alternatively
Flashing Amber and Off
Green alternatively
Flashing Amber and Red
Green alternatively
Green Flashing Amber
Green Off
Green Green
Green Amber
Green Red

CPU Management Port LEDs

The LED for the 10/100/1000 Management port is integrated on the connector itself. There are two LEDs
in the connector—the LED on the left indicates the Link/Activity status and the LED on the right
indicates the duplex status of the link.
Table 1-6
LED
Left
Right
Cisco ASR-920-24SZ-IM, ASR-920-24SZ-M, ASR-920-24TZ-M Aggregation Services Router Hardware Installation Guide
1-14
Indication
Power in the system is all right and FPGA
configuration is taking place.
FPGA Image Validation Error.
Upgrade FPGA image error, continuing with
Golden FPGA image.
FPGA configuration successful and Digital
code signing successfully validated FPGA
image. Digital code signing passed the
control to Microloader to boot ROMMON.
Digital code signing reported failure in
ROMMON image validation.
ZTP process has begun.
IOS-XE image is booting.
Successfully booted and system is operating
normally.
A minor alarm or synchronization is in
Holdover or free-running mode
A major or critical alarm (high temperature
reported for any sensor) or multiple fan
failure.
CPU Management Port LED Indication
LED State
Green
Blinking Green
Amber/Orange
Blinking Amber/Orange
Off
Green
Off
Indication
Link up in 1000 Mbps
Activity in 1000 Mbps
Link up in 100/10 Mbps
Activity in 100/10 Mbps
Link down
Link up in full duplex
Link up in half duplex
Chapter 1 Overview
Comment
Permanent Amber/Off
indicates FPGA configuration
failure.
System is in unresponsive
state. No console messages.
—
—
System is in unresponsive
state. No console messages.
Both LEDs turn Green once
provisioning is complete.
—
—
—