Activating A Dc Power Supply; Activating An Ac Power Supply; Connecting A Router To The Network; Connecting Console Cables - Cisco ASR-920-24SZ-IM Installation Manual

Connecting a Router to the Network

Activating a DC Power Supply

Perform the following procedure to activate a DC power supply:
Step 1 Remove the tape from the circuit-breaker router handle, and restore power by moving the circuit-breaker
router handle to the On (|) position.
Step 2 Verify power supply operation by checking if the respective power supply front panel LED (PS0 or PS1)
is green.
Step 3 If the LEDs indicate a power problem, see
Step 4 If you are connecting a redundant DC power supply, repeat these steps for the second power source.
If you are connecting a redundant DC power supply, ensure that each power supply is connected to a
Note
separate power source in order to prevent power loss in the event of a power failure.

Activating an AC Power Supply

Perform the following procedure to activate an AC power supply:
Plug the power cord into the power supply.
Step 1
Connect the other end of the power cord to an AC-input power source.
Step 2
Verify power supply operation by checking if the respective power supply front panel LED (PS0 or PS1)
Step 3
is green.
If the LEDs indicate a power problem, see
Step 4
information.
Step 5 If you are connecting a redundant AC power supply, repeat these steps for the second power source.
If you are connecting a redundant AC power supply, ensure that each power supply is connected to a
Note
separate power source in order to prevent power loss in the event of a power failure.
Connecting a Router to the Network
The following sections describe how to connect a Cisco ASR 920-24SZ-IM, ASR-920-24SZ-M,
ASR-920-24TZ-M Router to the network:
•
•
•
•
•
•
•
•
Cisco ASR-920-24SZ-IM, ASR-920-24SZ-M, ASR-920-24TZ-M Aggregation Services Router Hardware Installation Guide
3-48
Connecting Console Cables, page 3-49
Connecting a Management Ethernet Cable, page 3-53
Installing and Removing SFP and SFP+ Modules, page 3-54
Connecting a USB Flash Device, page 3-54
Connecting Timing Cables, page 3-55
Connecting Ethernet Cables, page 3-57
Connecting Cables to SFP Modules, page 3-58
Connector and Cable Specifications, page 3-58
Chapter 5, "Troubleshooting."
Chapter 5, "Troubleshooting"
Chapter 3 Installing
for troubleshooting