Installing The Router Chassis In The Rack - Cisco ASR-920-24SZ-IM Installation Manual

Chapter 3 Installing
Secure the bracket to the chassis with the screws removed when performing Step 1. The recommended
Step 3
maximum torque is 10 in.-lb.
Repeat Step
Step 4

Installing the Router Chassis in the Rack

Ensure adequate air flow when mounting the router in a rack. For more information, see the
Note
Guidelines" section on page
Install the cable guides before installing the router in a 19-inch EIA rack. See
Note
Guides, page
To install the router chassis in the equipment rack, perform these steps:
Position the chassis in the rack as follows:
Step 1
•
•
Align the mounting holes in the bracket (and optional cable guide) with the mounting holes in the
Step 2
equipment rack.
The following figure shows how to install the Cisco ASR-920-24SZ-IM Router in a 19-inch EIA rack.
Cisco ASR-920-24SZ-IM, ASR-920-24SZ-M, ASR-920-24TZ-M Aggregation Services Router Hardware Installation Guide
3 and Step 3 for the other bracket.
10.
3-13.
If the front of the chassis (front panel) is at the front of the rack, insert the rear of the chassis between
the mounting posts.
If the rear of the chassis is at the front of the rack, insert the front of the chassis between the
mounting posts.
Installing the Router in a Rack
"Air Flow
Attaching the Cable
3-11