Attaching The Cable Guides - Cisco ASR-920-10SZ-PD Installing Manual

Attaching the Cable Guides

Step 3
Install the eight 12-24 x 3/4-inch or 10-32 x 3/4-inch zinc-plated steel screws through the holes in the bracket and into
the threaded holes in the equipment rack posts.
Step 4 Use a tape measure and level to verify that the chassis is installed straight and level.
Attaching the Cable Guides
The Cisco ASR-920-10SZ-PD Router supports the following cable guides:
• A920-CBL-GUIDE-PC (left and right)—help in routing the cables from all components on the front
Assemble the cable guides before installing the chassis on the rack.
Note
To install the cable guides, perform these steps:
SUMMARY STEPS
1. Position the cable guide-left and cable guide-right against the front of the chassis and align the four screw
holes, as shown in figure below.
2. Secure the cable guides with the four M4x6mm screws supplied with the cable guide kit. The recommended
maximum torque is 10 in-lb (1.12 N-m)
Cisco ASR 920-10SZ-PD Aggregation Services Router Hardware Installation Guide
4
panel thereby enabling a proper cable-bending radius.
Installing the Cisco ASR-920-10SZ-PD Router