Installing The Router Chassis In The Rack - Cisco ASR 903 Hardware Installation Manual

Chapter 3 Installing the Cisco ASR 903 Router

Installing the Router Chassis in the Rack

To install the router chassis in the equipment rack, perform these steps:
Position the chassis in the rack as follows:
Step 1
•
•
Align the mounting holes in the bracket (and optional cable guide) with the mounting holes in the
Step 2
equipment rack.
Caution Do not use interface module and power supply ejector handles to lift the chassis; using the handles to
lift the chassis can deform or damage the handles.
Figure 3-3
Figure 3-4
OL-25178-04
If the front of the chassis (front panel) is at the front of the rack, insert the rear of the chassis between
the mounting posts.
If the rear of the chassis is at the front of the rack, insert the front of the chassis between the
mounting posts.
Installing the Chassis in a 19-inch EIA Rack
Installing the Chassis to support the Japanese JIS Rack Standard
Installing the Router in a Rack
Cisco ASR 903 Router Hardware Installation Guide
3-3