B-ALU Extern 180 Instructions For Installation And Use Manual page 57

7.2. Terminal assignment
1 – 2 MOT
3 – 6 ENC
7 LCK
8 CMN
9 – 10 LC/CH2
11 CMN
12 LP
13 LS
14 CMN
15 CTRL24Vdc
16 CMN
17 OUT24Vdc
18 TA
19 TC
20 TAL
21 TD
22 CMN
23 TB
24 CP
25 FS
26 FI
27 ANT
28 ANT
29 CMN
30 EMRG1
31 EMRG2
In this way, the controller has saved the end potition
and the operating forces that are necessary. If
„PROGRAM" flashes on the display, the learning
operation must be restarted.
Motor connection (made at the factory)
Encoder connection (3 – blue/ 4 – green / 5 – grey / 6 – yellow) (done at the factory)
Emergency unlocking ("Motor free" text on the display)
Common connection
Connection of an externally powered ambient lamp (max. 30 V sc/dc, 1A) or pick-up 2. wireless
channel (potential-free switching contact)
Common termination
Flashing lamps (24 V dc / max. 25 W flashing or 12.5 W continuously)
Pilot lamp "Gate open" (24 V dc / max. 3 W)
It flashes slowly while opening and flashes quickly while closing.
It lights up continuously if the gate is blocked while closing.
It goes off when the gate is closed.
Common connection
24 V dc for feeding the monitored light barrier transmitter
Common connection
24 V dc for feeding the light barrier receiver
ATTENTION! Terminals 15 + 17 should be loaded with max. 10 W!
Defined opening command
Defined closing command
Partial opening (1-9 m programmable)
Dynamic starting pule
Opening with pulse blocking until the gate opens, and pulse when the closure opens
Opening – Stopping – Closing - Stopping
Common connection
Emergency stop / Connecting the safety contact strip
Reversing safety device / Connecting the safety contact strip
Stopping light barrier connection in the closing operation
After release, the quick movement is continued / connecting the safety contact strip
Reversing safety device in closing operation / Connecting the safety contact strip
Antenna connection (Signal) (RG 58 / 50 Ω)
Antenna connection (Sheath)
Common connection for emergency operation
Operates the gate in which the controller is bypassed
If the drive is on the left side, the gate is closed, and with the drive on the right side it is opened
Operates the gate in which the controller is bypassed
If the drive is on the left side, the gate is opened, and with the drive on the right side it is closed
ENGLISH
16