The Setup Menu - Burmester 082 Owner's Manual

The setup menu allows the easy programming of certain basic settings of the integrated amplifier 082.
Activating setup Press the button SETUP (11) on the front panel or press either the SETUP- or the D MENU
button on the remote control.
Select menu item The different items of the setup menu are selected in the sequence specified below by
repeatedly pressing the SETUP or D MENU button.
The activated menu item is indicated on the left side of the display (3).
Change settings To change the setting of an activated menu item, rotate the VOLUME knob (8)
counterclockwise to lower the set value or clockwise to increase it. To change the settings
you can also use the VOLUME buttons on the remote control.
The selected value of the menu item is indicated on the right side of the display (3).
Deactivating setup
The setup menu is closed automatically after 10 seconds, when no adjustment has been
made.
Menu items The following table lists all items that can be adjusted using the setup menu. The factory
default settings have been underlined.
MENU ITEM
Input level CD
Input level TUNER
Input level TAPE
Input level AUX1
Input level AUX2
Volume
Output amplification
Input level The input level adjustment feature serves to avoid big jumps in volume, when switching
between signal sources with different output levels.
Volume This menu item allows you to preset the volume level, when the 082 is switched on. The
setting L represents LAST, which means that when you switch on the 082, it starts at the
same volume level it was last playing before it was switched off. The maximum value is
limited to 30.
Output amplification To achieve the best match with your loudspeakers, the output level of the amplification
stages may be adjusted. HI stands for high amplification, LO accordingly for low
amplification. When switching between these settings, the relays are briefly switched off to
avoid malfunction.

THE SETUP MENU

DESCRIPTION
Input level adjustment for input CD
Input level adjustment for input TUNER
Input level adjustment for input TAPE
Input level adjustment for input AUX1
Input level adjustment for input AUX2
Selecting initial volume (L=Last volume)
Power amplification high (HI) or low (LO)
DISPLAY
7
VALUE
L-CD -9 to 0 to +9
L-TU -9 to 0 to +9
L-TP -9 to 0 to +9
L-A1 -9 to 0 to +9
L-A2 -9 to 0 to +9
VOL 0 to 5, 10, 15, 20, L
PA HI / LO