System > Snmp Settings > Snmp Engine Id; System > Snmp Settings > Snmp Trap Settings - D-Link DGS-1210-12TS/ME User Manual

4 Configuration
Host IP Address: Select IPv4 or IPv6 and specify the IP address of SNMP management host.
SNMP Version: Specify the SNMP version to be used to the management host.
Community String/SNMPv3 User Name: Specify the community string or SNMPv3 user name for the
management host.
Click Apply to create a new SNMP host, Delete to remove an existing host.
System > SNMP Settings > SNMP Engine ID
The Engine ID is a unique identifier used to identify the SNMPv3 engine on the Switch.
Input the Engine ID then click Apply to apply the changes and click Default resets to default value.
System > SNMP Settings > SNMP Trap Settings
The SNMP Trap Settings page provide user to Specify whether the device can send SNMP
SNMP Authentication Traps: Specifies the device to send authentication failure notifications.
System Coldstart Traps: Specifies the device to send SNMP coldstart notifications.
System Warmstart Traps: Specifies the device to send SNMP warmstart notifications.
DGS-1210 series Metro Ethernet Managed Switch User Manual
Figure 4.32– System > SNMP Settings > SNMP Host Table
Figure 4.33 – System > SNMP Settings > SNMP Engine ID
Figure 4.34 – System > SNMP Settings > SNMP Trap Settings
34
notifications.