Snmp Engine Id - D-Link DGS-3324SRi User Manual

D-Link DGS-3324SRi Intelligent Stackable Gigabit Ethernet Switch
To add a new entry to the Switch's SNMP Group Table, click the Add button in the upper left-hand corner of
the SNMP Host Table page. This will open the SNMP Host Table Configuration page, as shown below.
The following parameters can set:
Parameter
IP Address
SNMP Version
Community String or
SNMP V3 User Name

SNMP Engine ID

The Engine ID is a unique identifier used for SNMP V3 implementations. This is an alphanumeric string used to
identify the SNMP engine on the Switch.
To display the Switch's SNMP Engine ID, open the Management folder, and then the SNMPV3 folder.
Finally, click on the SNMP Engine ID link. This will open the SNMP Engine ID Configuration page, as
shown below.
Figure 5- 10. SNMP Host Table
Figure 5- 11. SNMP Host Table Configuration
Description
Type the IP address of the remote management station that will serve as
the SNMP host for the Switch.
V1 – To specifies that SNMP version 1 will be used.
V2 – To specify that SNMP version 2 will be used.
V3 – To specify that the SNMP version 3 will be used. The user may
choose between NoAuth-NoPriv, Auth-NoPriv and Auth-Priv.
Type in the community string or SNMP V3 user name as appropriate.
134