Security > 802.1X > 802.1X User; Security > 802.1X > 802.1X Authentication Radius - D-Link DGS-1210-12TS/ME User Manual

4 Configuration
received. The Switch then requests the identity of the client and begins relaying authentication
messages between the client and the authentication server.
The default setting is Auto.
Direction: Sets the administrative-controlled direction on the port. The possible field values are:
Both – Specify the control is exerted over both incoming and outgoing traffic through the controlled
port selected in the first field.
In – Disables the support in the present firmware release.
Click Apply to make the configurations take effect.
Security > 802.1X > 802.1X User
The 802.1X User page allows user to set different local users on the Switch. Enter a 802.1X User name,
Password and Confirm Password. Properly configured local users will be displayed in the table.
Click Add to add a new 802.1X user.
Security > 802.1X > 802.1X Authentication RADIUS
The 802.1X Authentication RUAIUS of the Switch allows you to facilitate centralized user administration as
well as providing protection against a sniffing, active hacker.
Index: Choose the desired RADIUS server to configure: 1, 2 or 3.
IP Address: Select IPv4 or IPv6 and enter the IP address.
Authentication Port (1 - 65535): Set the RADIUS authentic server(s) UDP port. The default port is 1812.
Accounting Port (1 - 65535): Set the RADIUS account server(s) UDP port. The default port is 1813.
Timeout (1 – 255 sec): This field will set the time the Switch will wait for a response of authentication from
the user. The user may set a time between 1 and 255 seconds. The default setting is 5 seconds.
Retransmit (1 – 255 times): This command will configure the maximum number of times the Switch will
accept authentication attempts. Users failing to be authenticated after the set amount of attempts will be
denied access to the Switch and will be locked out of further authentication attempts. Command line
interface users will have to wait 60 seconds before another authentication attempt. Telnet and web users will
DGS-1210 series Metro Ethernet Managed Switch User Manual
Figure 4.142 - Security > 802.1X > 802.1X User
Figure 4.143 - Security > 802.1X > 802.1X Authentication RUDIUS
9 7
9 7