Monitoring > Packets > Received (Rx) - D-Link DGS-1210-12TS/ME User Manual

4 Configuration
Figure 4.179 - Monitoring > Packet s > Transmitted (TX) (table for Bytes and Packets)
The following fields can be set or viewed:
Time Interval: Select the desired setting between 1s and 60s, where "s" stands for seconds. The default
value is one second.
Record Number: Select number of times the Switch will be polled between 20 and 200. The default value is
200.
Bytes: Counts the number of bytes successfully sent from the port.
Packets: Counts the number of packets successfully sent on the port.
Unicast: Counts the total number of good packets that were transmitted by a unicast address.
Multicast: Counts the total number of good packets that were transmitted by a multicast address.
Broadcast: Counts the total number of good packets that were transmitted by a broadcast address.
Show/Hide: Check whether or not to display Bytes and Packets.
Clear: Clicking this button clears all statistics counters on this window.
View Table: Clicking this button instructs the Switch to display a table rather than a line graph.
View Line Chart: Clicking this button instructs the Switch to display a line graph rather than a table.
Monitoring > Packets > Received (RX)
The Received (RX) page displays the following graph of packets received on the Switch. To select a port to
view these statistics for, use the Port pull-down menu. The user may also use the real-time graphic of the
Switch at the top of the web page by simply clicking on a port.
Figure 4.180 - Monitoring > Packets > Received (RX) (line graph for Bytes and Packets)
DGS-1210 series Metro Ethernet Managed Switch User Manual
1 1 7
1 1 7