Table of Contents
Advertisement
2 Hardware Installation
2
Hardware Installation
This chapter provides unpacking and installation information for the D-Link DGS-1210/ME Metro Ethernet
Switch.
Step 1: Unpacking
Open the shipping carton and carefully unpack its contents. Please consult the packing list located in the
User Manual to make sure all items are present and undamaged. If any item is missing or damaged, please
contact your local D-Link reseller for replacement.
One D-Link Metro Ethernet Switch
One multi-language Getting Started Guide
One CD
One RJ-45 console cable
Power cord clip
Power cord
Rack mount kit
Rubber feet
If any item is found missing or damaged, please contact the local reseller for replacement.
Step 2: Switch Installation
For safe switch installation and operation, it is recommended that you:
Visually inspect the power cord to see that it is secured fully to the AC power connector.
Make sure that there is proper heat dissipation and adequate ventilation around the switch.
Do not place heavy objects on the switch.
Desktop or Shelf Installation
The DGS-1210/ME series switches come with a strip of four adhesive rubber pads that can be placed on the
bottom of the device to prevent the device from damaging the desktop or shelf it is places on. To attach the
rubber pads, simply remove them from the adhesive strip and stick one pad on each corner on the bottom
panel of the Switch.
Rack Installation
The switch can be mounted in an EIA standard size 19-inch rack, which can be placed in a wiring closet with
other equipment. To install, attach the mounting brackets to the switch's side panels (one on each side) and
secure them with the screws provided (please note that these brackets are not designed for palm size
switches).
DGS-1210 series Metro Ethernet Managed Switch User Manual
Figure 2.1 – Attach the adhesive rubber pads to the bottom
Figure 2.2 – Attach the mounting brackets to the Switch
1
3
1
3
- Quick Links:
- Configuration > 802.1Q Vlan
Hide quick links:
Advertisement
Table of Contents
