Safety Instructions - ACME LED-PAR 100 WW/CW User Manual

1. Safety Instructions

Please read the instruction carefully which includes important
information about the installation, usage and maintenance.
WARNING
 Please keep this User Manual for future consultation. If you sell the fixture to another user, be sure
that they also receive this instruction booklet.
 Please unpack and check carefully there is no transportation damage before using the fixture.
 Please disconnect main power before servicing and maintenance.
 The unit must be installed in a location with adequate ventilation, at least 50cm from adjacent
surfaces. Be sure that no ventilation slots are blocked.
 The maximum ambient temperature is Ta: 40℃. DO NOT operate it where the temperature is higher
than this.
 DO NOT connect the device to any dimmer pack.
 The housing must be replaced if they are visibly damaged.
 Unit surface temperature may reach up to 85℃. Don't touch the housing bare-hand during its
operation. Turn off the power and allow about 15 minutes for the unit to cool down before replacing
or serving.
 There are no user serviceable parts inside the fixture. Do not open the housing or attempt any
repairs by yourself. In the unlikely event your fixture may require service, please contact your nearest
dealer.
 In the event of serious operating problem, stop using the fixture immediately. Never try to repair the
fixture by yourself. Repairs carried out by unskilled people can lead to damage or malfunction. Please
contact the nearest authorized technical assistance center. Always use the same type spare parts.
2A