Optionai accessories
Fitting the optionai flying bracket
The optionai flying bracket is fixed to the underside of the machine using 4 M4
taptite screws, supplied with the bracket.
Remove the fluid container from the machine before tipping up the unit to
access the underside.
Do no! install the machine over people's heads. Ensure that !he mounting surface
is strong enough to hold !he weight ofthe machine.
&,
You should also attach a safety bond to !he handle ofthe machine.
20
Optionai accessories
Fitting the DMX decoder module (Magnum 1200)
The optionai DMX decoder replaces the blanking plate on the rear of the
Magnum 1200.
DANGER! Disconnect !he power supply before removing !he blanking plate. Live
parts inside!
1. Remove and keep safe the two screws holding in the blanking plate,
and remove the plate.
2.
Locate the DMX interlace ribbon cable inside the rear of the unit and
plug onto the connector on the DMX interlace circuit board (PL5).
3.
lf you cannot locate the ribbon cable, you will need to remove !he main
covers of the unit. The ribbon cable connects the main circuit board to
the DMX interlace.
4.
Fit the new DMX module into the rear panel and tighten the screws.
5.
Refit any covers you have removed before reconnecting the power
supply.
Optionai accessories
21